Subject: My island does not show up on the WEAP interface Posted: 4/1/2015 Viewed: 19450 times
Hi There....
I am working with an island called Carriacou....a very small island north of Grenada in the Caribbean. When I import my shapefile (in WGS 84)....it does not show in the interface. I also realise that whereas there are outlines for all of the other major islands and land masses, there is none for Carriacou. When I zoom into the location where the shp is supposed to fall, nothing is there. Any advice/ feedback here would be greatly appreciated!
Mr. Jack Sieber
Subject: Re: My island does not show up on the WEAP interface Posted: 4/1/2015 Viewed: 19444 times
I am sorry, but this island is not included in the country basemap that is included with WEAP. However, if you have your own GIS shapefile that includes Carriacou, you can load that layer in WEAP. On the Schematic menu, choose "Add Vector Layer"
Jack
Ms. Anuradha Maharaj
Subject: Re: My island does not show up on the WEAP interface Posted: 4/1/2015 Viewed: 19434 times
Hi Jack!
Thanks for the response! Yes, I am adding the shp file via "Add Vector Layer". However, my shp is not showing up on the interface....shouldn't it at least fall in the vicinity of Grenada (in the sea) since there isn't a basemap for this island?
Mr. Jack Sieber
Subject: Re: My island does not show up on the WEAP interface Posted: 4/1/2015 Viewed: 19427 times
The WEAP basemaps use the WGS84 projection (lat/lon). If your shapefile uses a different projection, it will not appear with the WEAP basemaps. Add your shapefile, then remove all the WEAP basemap layers, then go to Schematic, Set Area Boundaries.
Jack
Ms. Anuradha Maharaj
Subject: Re: My island does not show up on the WEAP interface Posted: 4/1/2015 Viewed: 19422 times
Thanks Jack! I tried those steps and it worked!
Topic "My island does not show up on the WEAP interface"
